Alphatech Fermax PBX EXP Guide d'installation télécharger pdf (Page 33)

4.7 System Setting

Parameter Value Meaning Basic

6# s

number of non-fitted buttons of basic module

The basic module is fitted with 2 buttons as standard, i.e. s = 0, s = 1 is set up

for basic module with one button and s = 2 for module without buttons. This

setting is a factory one, no service can change it and so it is recommended not

to change this parameter.

Note: Connecting. to the line the value of this parameter is checked and if not

satisfactory form unknown reasons, so it is set up to s = 0 (fitted with 2 buttons).

Atention !!! This parameter does not basically affect the correct function

of guard.

Parametr Value Description Basic

6 z

Switching off acoustic signalization

In default is status of Door phone signalling acoustically. It can cause a problem of

incorrect detection of tones by PBX. By parametr „z“ you can switch off this

acoustic signalization. The values are

z=0 – all signalling is switched off

z=1 – pick up and hang up tones are active only

z=2 – other tones active only

(except pick up and hang up)

z=3 – all tones are active – default

Parametr Value Description Basic

Delay of line connection ( Siemens PBX)

The delay of line picks up ( OFF HOOK) for new PBX types (particularly

Siemens) is:

t=1 – standard operation

t=0 – delayed start

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Pas de commentaire

Alphatech Fermax PBX EXP Guide d'installation Page 33